DeTomaso Mailing List: April 1997, Message #93
     



From: kbecker@deltanet.com (Kevin Becker)

Subject: Recommendation wanted

Date: Sun, 13 Apr 1997 21:18:38 -0700 (PDT)



To:  All fellow pantera owners



I recently drilled the drain holes in the bottom of the "S" shaped rear

wheel housing brace.  I did not get any water, however, I did get some rust

particles out.  The left side had more than the right.



Now that the inside of these tubes are accessible, what is the best way to

treat them so that this does not happen again?  Besides not driving in the

rain, etc?  I was thinking more along the lines of POR-15, Extend, etc.

introduced through a hollow wand through the newly drilled drain holes.



Is there a better method?  If these rust killing compounds are used, which

is the best?



Thank you in advance for your assistance.



Kevin Becker

'74 L #6240