DeTomaso Mailing List: October 98, Message #289

If someone would make these, I'd buy one (presume reasonable $).


> -----Original Message-----
> From: JDeRyke@aol.com <JDeRyke@aol.com>
> To: Multiple recipients of list <detomaso@realbig.com>
> Date: Tuesday, October 06, 1998 1:34 PM
> Subject: Re: Re: Update on #4544
> 
> 
> >In a message dated 10/5/98 4:32:30 PM, petersgermanauto@internetmci.com
> wrote:
> >snip.....
> ><>
> >
> >The loading is mostly in compression on this c-member; I built a c-member
> out
> >of a 2-1/2" dia  aluminum thickwall pipe with plates on each end.
> Slotting
> the
> >plates and cutting a box-wrench access hole in the side of the pipe at
> each
> >end allows the a-arm mount nuts to hold the c-member in place. To remove,
> >loosen the nuts, rotate the c-member 180 degrees & drop out the bottom.
> Piece
> >of cake! Cheers- J DeRyke
> >
> >
> 
> 
> 
>