DeTomaso Mailing List: December 98, Message #226

[previous topic] [index] [next] [next topic]
From: Rob McMullen <rmcmullen@dev.tivoli.com>
Subject:throwout bearing & hub
Date: Tue, 8 Dec 1998 09:32:28 -0500

How do you separate the throwout bearing and the hub?  Always a good
idea to replace the throwout bearing whenever you are doing clutch work,
right? :)

The Tech Manual says something helpful like "Remove the release bearing
from the hub" as if it would be easy, but mine appears extremely stuck
-- as if it were pressed in via very large hydraulic press.  Is this the
case?

How about installation?  Pressed in again?

Thanks,

Rob

PS: it has been a long time, but 351W Diary #2 is due here shortly.  By
this weekend, I should have a long block!
[previous topic] [index] [next] [next topic]