DeTomaso Mailing List: June 99, Message #279
![[previous topic]](../images/prev_topic.gif)
![[previous]](../images/prev.gif)
![[index]](../images/index.gif)
![[next topic]](../images/next_topic.gif)
| From: | David Doddek <pantera@pobox.com> |
| Subject: | Re: Shorter Shifter - 74L |
| Date: | Sat, 12 Jun 1999 01:19:40 -0400 |
Yea, make a shift knob with a deeper hole. Gets you about an inch. I was
going to make some on a cnc lathe but never got the time.
Dave "too busy" D
At 12:45 PM 6/11/99 -0400, you wrote:
>Is there any other way to shorten the shifter lever other than cutting
>a center section out and rewelding?
>
>
>_________________________________________________________
>Do You Yahoo!?
>Get your free @yahoo.com address at http://mail.yahoo.com
>
>
>
>