DeTomaso Mailing List: October 99, Message #64

From:	"Al C." <chelini@earthlink.net>
Subject:	Clutch assembly
Date:	Fri, 1 Oct 1999 20:41:39 -0400


  Well, I'm going to yank out the ZF anyway, so I may as well replace
the old clutch while it's apart.
  I wondered what the latest hot tip is for an (after market, perhaps?)
clutch and disk assembly.
  The last to go in was a McLeod which required relieving the webs cast
into the bell housing interior with a grinder so that the clutch
pressure plate fly weights would clear without banging into them! Anyone
have any suggestion on what to put in or to avoid???
  Thanks, Al.