DeTomaso Mailing List: May 2000, Message #33
![[previous topic]](../images/prev_topic.gif)
![[previous]](../images/prev.gif)
![[index]](../images/index.gif)
![[next topic]](../images/next_topic.gif)
| From: | MikeLDrew@aol.com |
| Subject: | Re: alignment (sorta) |
| Date: | Tue, 2 May 2000 00:45:10 -0400 |
JB wrote:
> I've heard about the offset bushings, but
the alignment guy recommended possibly machining the rear surface of the
block holding the upper ball joint (thus moving the top of the spindle
towards the rear of the car) and adding shims to the front surface. Any
comments?
>>>Larry Stock had this done to his race car and swears by it (in fact, the
guys at Custom Alignment are the ones that did it for him.)
I wonder why you only have 1.5 degrees? I was about to get about 2 3/4
degrees on my car...
Mike