[DeTomaso] Pulling ZF

[charles buthala]

I did not see any leaking from the ZF, not sure about the rear main or crank seal.  Are these reparable without overhauling or removing the engine.  I am basically not engine savvy.  
  I put so much grease in the half shafts during rebuilding the car that I have seen globs of grease flung all over the engine compartment, that is why I thought is was from the half shafts.

MikeLDrew at aol.com wrote:
  
In a message dated 8/2/06 8:12:50, charlesbuthala at yahoo.com writes:

<< I think what happen is my 1/2 shafts were spewing grease and when I went 
around the hair pin corner some of that grease was flung into the sight hole of 
the bell housing. >>

>>>I find that very, very unlikely. I would suspect either a leaking front 
seal on the ZF or a leaking crank seal or main seal on the motor.

Mike


 			
---------------------------------
See the all-new, redesigned Yahoo.com.  Check it out.