[DeTomaso] Brake Line Fitting

[Forest Goodhart]

When I did this I just bought a 3/16" tee for inverted flare fittings and 
three 3/16" male inverted flare nuts. I cut the old bubble flares off,
installed the new nuts and re-flared using a 3/16" double flare.
Forest
----- Original Message ----- 
From: "Daniel C Jones" <daniel.c.jones2 at gmail.com>
To: "DeTomaso Forum" <detomaso at realbig.com>
Sent: Thursday, June 01, 2006 5:35 PM
Subject: [DeTomaso] Brake Line Fitting


> Does anyone recall the style of fitting used by the three lines
> that go into the pressure release valve for the front brakes?
> I had to remove the valve to install a 3 point brace in the
> front trunk and I'd like to replace it with a 3 port fitting.
> Before I lop off the ends and re-flare the lines, I thought I'd
> see if I could find the proper style fitting.  Do any of the
> vendors carry the fitting?
>
> Thanks,
> Dan Jones
> _______________________________________________
>
> Detomaso Forum Managed by POCA
>
> Archive Search Engine Now Available at http://www.realbig.com/detomaso/
>
> DeTomaso mailing list
> DeTomaso at realbig.com
> http://ftl.realbig.com/mailman/listinfo/detomaso