[DeTomaso] Brake Line Fitting

[Daniel C Jones]

That's the back up plan, if I can't find the proper tee fitting.

Thanks,
Dan Jones


On 6/2/06, Forest Goodhart <forestg at worldnet.att.net> wrote:
>
> When I did this I just bought a 3/16" tee for inverted flare fittings and
> three 3/16" male inverted flare nuts. I cut the old bubble flares off,
> installed the new nuts and re-flared using a 3/16" double flare.
> Forest
> ----- Original Message -----
> From: "Daniel C Jones" <daniel.c.jones2 at gmail.com>
> To: "DeTomaso Forum" <detomaso at realbig.com>
> Sent: Thursday, June 01, 2006 5:35 PM
> Subject: [DeTomaso] Brake Line Fitting
>
>
> > Does anyone recall the style of fitting used by the three lines
> > that go into the pressure release valve for the front brakes?
> > I had to remove the valve to install a 3 point brace in the
> > front trunk and I'd like to replace it with a 3 port fitting.
> > Before I lop off the ends and re-flare the lines, I thought I'd
> > see if I could find the proper style fitting.  Do any of the
> > vendors carry the fitting?
> >
> > Thanks,
> > Dan Jones
> > _______________________________________________
> >
> > Detomaso Forum Managed by POCA
> >
> > Archive Search Engine Now Available at http://www.realbig.com/detomaso/
> >
> > DeTomaso mailing list
> > DeTomaso at realbig.com
> > http://ftl.realbig.com/mailman/listinfo/detomaso
>
> _______________________________________________
>
> Detomaso Forum Managed by POCA
>
> Archive Search Engine Now Available at http://www.realbig.com/detomaso/
>
> DeTomaso mailing list
> DeTomaso at realbig.com
> http://ftl.realbig.com/mailman/listinfo/detomaso
>